Raspberry Pi 4 8GB 64-bit OctoPi and OctoPrint build Part 3

In part 3 of this series we will dive into putting together an Arducam 5mp camera and getting it hooked up to replace a cheap USB 1080p camera from my last setup. I will also dive into some of my favorite Octoprint plugins that I use. Hang tight and join in as I put together an Arducam vs USB shootout.

When speaking of the plugins I like to use:

• Bed Level Visualizer –https://plugins.octoprint.org/plugins/bedlevelvisualizer/
• BLTouch Plugin – https://plugins.octoprint.org/plugins/BLTouch/
• GCode Viewer – https://docs.octoprint.org/en/master/bundledplugins/gcodeviewer.html
• PrintTimeGenius – https://plugins.octoprint.org/plugins/PrintTimeGenius/
• Themeify – https://plugins.octoprint.org/plugins/themeify/

Hardware used in this video:

Raspberry 4 Kit on Amazon: https://amzn.to/3lBBlAr

128GB Card https://amzn.to/38KOZOg

Creality CR-10v2 3D Printer: https://amzn.to/3lNfvKB

Arducam 5MP Pi Camera: https://amzn.to/2IwdCDH

Camera long cable: https://amzn.to/32MT0hc

USB Camera: https://amzn.to/36I3XSe